Designated Use; Safety Instructions - Soehnle Professional 2790 Instrucciones De Manejo

ENGLISH
Thank you for choosing this Soehnle product. All the features of this product were designed
to the state of the art and are optimised for simple and straightforward use.
If you have any queries or problems which are not dealt with in these operating instruc-
tions, please contact your dealer or visit our website at www.soehnle.com.

Designated use

The Soehnle 2790 indicator is designed for use in weighing systems. Commercially availa-
ble strain gauge-type load cells and platforms with strain gauge-type load cells can be con-
nected to the indicator. The Soehnle 2790 display unit is designed for use involving com-
pulsory (Class III) and non-compulsory calibration within the EU. It corresponds to the
design described in the model approval certificate and the current statutory requirements of
EU directives 90/384/EWG, 89/336/EWG, 73/23/EWG and the European standard EN
45501.

Safety instructions

Before putting the device into use, please read with care the information given in the
Operating Manual. It contains important instructions for installation, proper use and mainte-
nance of the device.
The manufacturer shall not be liable for damages arising out of failure to heed the following
instructions:
When using electrical components under increased safety requirements, always comply
with the appropriate regulations. Never perform work on the device while voltage is applied.
Improper installation voids the warranty. The electrical power source must match the
ratings printed on the type label of the device. The device is dust-proof and splash-proof in
accordance with protection class IP 65. Please make sure that all seals are undamaged. In
battery operation, you must keep the power socket closed using the supplied rubber cap.
Have the complete system checked regularly by authorised personnel. N.B.: even though
the device complies with protection class IP 65, the power plug must never be exposed to
moisture. Do not use any lengths of cable other than those supplied.
The device is designed for use within buildings. Observe the permissible ambient tempera-
tures for use (Technical Information).
The device meets the requirements for electromagnetic compatibility. Do not exceed the
maximum values specified in the applicable standards.
If you have any problems, contact your local Soehnle service partner.
In explosion hazard area, only use the scale in accordance with the indications on the
nameplate.
Comply with all national laws.
Cleaning
It is sufficient to clean the scale using a damp cloth and a normal cleaning agent. Do not
use any scourers.
12