Installation And Commissioning; Display Symbols - Soehnle Professional 2790 Instrucciones De Manejo

!
#
$
%

Installation and commissioning

"
The display unit is already mounted on the scale. If
necessary, use the supplied bracket to place it on a
table or fix it to the wall.
1. For table use, insert the rubber feet.
2. For wall use, fix the bracket to the wall approx.
110-150cm above the ground.
3. Insert the display unit into the bracket.
4. Connect the power supply ...
5. ... and/or insert (rechargeable) batteries (4 x 1.5V
AA). Then slacken the two screws on the left side
of the housing.
6. Erect the platform at the point of use.
Using a spirit level, ensure that the platform is
horizontal.
The scale is ready for use.
A short warm-up period of a couple of minutes after
switch-on stabilises the measured values. Place the
weighing product carefully on the scale. Do not keep
any loads permanently on the platform. Avoid any
&
knocks or overloading above the stated maximum
load. These could damage the scale.
The operating keys

Display symbols

On-Off
Zero position
Tare
Print
Function key (see Page 17)
Display is fixed to improve legibility.
Replace the batteries or charge the rechar-
geable batteries.
Zero message
Net weight
Piece mode
Active weighing area
ENGLISH
15