Additional Functions; Hold Function - Soehnle Professional 2790 Instrucciones De Manejo

Additional functions

You can assign any of the following functions to the F
key: Count, Hold, Unit switch. The standard function
is Count. You can make changes in User mode (p.
18/19).
Count
When Count mode is active: Press the
The reference items to be placed on the scale are
displayed.
Pressing the key again increments the amount of
reference items in the following steps: 1/2/5/10/25/50.
Place the items on the scale in accordance with the
specifications.
Confirm this by pressing the
Place the required amount of items on the scale.
Read-off the amount.
To switch to items with a different reference weight,
press the key again.
To switch to Weigh mode, press the

Hold function

When this mode is active, press the
flashes until the value is determined and frozen.
These 6 modes are settable in User mode:
Mode
Manual At a standstill outside
the zero range
Automatic
Slave pointer, For weight increase
manual
and repeated standstill
Slave pointer,
automatic
Maximum value, of the maximum
manual
weight reached
(without being at a standstill)
Maximum value,
automatic
kg/lb switch (with non-calibratable units)
Your service partner can activate 2 different func-
tions:
Assignment of the F key to switch units.
(On restarting, the most recently chosen unit is
displayed).
General restriction to kg or lb (F key can be assigned
to Count or Hold).
ENGLISH
key.
key.
key. "Hold"
Hold Remove by pressing
Remove load from scale
Remove load from scale
Remove load from scale
key.
key
key
key
17