Technical Data - Soehnle Professional 2790 Instrucciones De Manejo

ENGLISH
!
"
77mm
20
143,7 mm
Messages
The scale sets the value
zero automatically when
it is switched on.
The zero range at power-
on is -5% ....+15% of the
weighing range.
If the scale is outside the
set tolerance range, the
display shown adjacent
appears.
Parts weight too small
Zeroing not possible
Taring is not possible
Print not permitted on
over- or underload
Switch to lbs
deactivated

Technical data

• Housing made of anodised aluminium
• Protection class IP 65, dust-proof and splash-proof.
• Operated by means of a tactile keypad.
• Plug-in power supply 100-240V, 57-63Hz
• Operating temperature -10° ..... +40° C
• Storage temperature -20° ..... +60° C
• Zero range -1 %... +3 % of the weighing range (max.)
• Zero range at power-on -5% ...+15% of the weighing
range.
• RS 232 (V24) interface for printer or IT connection.
For a description of the interface, please contact your
Soehnle service partner.
Elimination
!
Either take the load off
the platform or press the
key to activate the cali-
brated zero point.
"
There is a mechanical
or electrical fault.
The scale is not suitable
for these parts.
The zero limit has been
exceeded or undershot.
Cannot tare the zero
display or negative values.
Place an object on the
scale / remove an object
from the scale.
Activation is described on
Pages 18/19.
In case of other error mes-
sages, please contact your
SOEHNLE service