Clatronic MWG 775 H Instrucciones De Servicio página 71

Special functions
Locking
• Press the STOP/CLEAR/CLOCK button and START/+30SEC./
CONFIRM button simultaneously to lock the device.
NOTE:
• The display will show the locked setting.
• The functions of the controls are blocked.
WARNING:
Turn the microwave off and disconnect the plug.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The
surface could be scratched and the glass could possibly break.
Interior
• Keep the interior of the microwave clean. Use a damp cloth to
remove splashing and spilling on the walls of the microwave. If the
device is very dirty, you may also use a mild detergent.
• Use a damp cloth to wipe the viewing window inside and outside,
and regularly remove splashing and spots caused by spilled liquids.
Exterior
• Clean the exterior walls of the enclosure with a damp cloth only.
Make sure no water enters the openings in the enclosure and there-
fore the inside of the device.
• Use a damp cloth to clean the switches. When cleaning the function
switches, first open the door in order to avoid accidentally switching
on the device.
Accessories
• Clean the glass tray occasionally with dish detergent or in the dish-
washer.
• Regularly clean the guide ring and the inside of the bottom. You may
remove the guide ring and manually clean it. Use a mild detergent
or glass cleaner. Dry thoroughly. Make sure to position the ring prop-
erly afterwards.
Odor
• In order to remove unpleasant odor in the microwave, place a bowl
suitable for microwave use filled with water and lemon juice in the
device and heat for approx. 5 minutes. Then wipe the oven with a
soft cloth.
Oven lights
• Please contact a service center for replacing the oven lights.
• Press the STOP/CLEAR/CLOCK button and START/+30SEC./
CONFIRM button again simultaneously to unlock.
Display function
• When pressing the MICROWAVE, GRILL, CONVECTION, COMBI.
or DEFROST button for 2-3 seconds during operation, the display
will show the current temperature or function setting.
Cleaning
Malfunctions are often just caused due to minor problems. Before con-
tacting our customer service, please check the table below:
Problem Possible cause
Radio or TV reception The electromagnetic
is interrupted during fields of this device
microwave operation. might interfere with the
pictures and sound of
special frequencies.
The device is not sup- Defect wall socket.
plied with electricity;
the display is black.
The display shows There was a power
"0:00" failure.
The device does The door is not prop-
not start operation. erly closed.
The display shows a
readout other than the
The START/+30SEC./
current time.
CONFIRM button
was not pressed after
selecting the function.
All controls are locked. The child-proof lock is
activated.
The turn-table causes There are dirt or for-
a scratching or abrad- eign objects in the area
ant noise. of the turntable shaft.
The operation is The device is defect.
terminated without any
obvious reason.
Troubleshooting
Notes/solution
This is normal and not
a malfunction. Position
the devices further
away from each other.
- Try another wall
socket.
- Check the main fuse
in your household.
Set the clock again.
Check if there are ob-
jects or food remains
jammed in the door.
Press the
START/+30SEC./
CONFIRM button,
or press the STOP/
CLEAR-CLOCK but-
ton to terminate the
process.
Press the STOP/
CLEAR/CLOCK
button and the
START/+30SEC./
CON-FIRM button
simultaneously to
unlock.
Remove possible ob-
jects and food remains
as described under
"Cleaning".
Please contact our
customer service.
71