Publicidad
Idiomas disponibles
Idiomas disponibles
CUT OUT DIMENSIONS
The dimensions of the cut-out are given in the diagram. (Dimensions are given in mm.)
ELECTRICAL CONNECTIONS
Any electrical work required to install this hob should be carried out by a qualified
electrician or competent person
THE HOB MUST BE EARTHED
This hob is designed to be connected to a 230 V 50 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated
on the hob rating label.
Ensure that the hob supply cable does not come into contact with surfaces with
temperatures higher than 50 deg. C.
FITTING THE HOB INTO THE WORKTOP
Carry out the building in of the hob as follows:
• Put the seals supplied with the hob, on the edges of the cut out taking care that the
seals meet without overlapping;
•
Place the hob in the cut out, taking care that it is centered
•
Fix the hob with the relevant fixing clamps and screws, as shown in the diagram. When
the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
- 30-
Publicidad
