Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the line length
• The device is equipped with a semi- auto type nylon line head that allows the operator to advance
the line without stopping the engine. When the line becomes short, lightly tap the head on the
ground while running the engine at full throttle.
• Each time the head is bumped, the line advance about 1 inch (25.4 mm). For better effect, tap the
head on hard soil. Avoid bumping in thick, tall grass as the engine may stall by overload.
1 - Tap knob
2 - Hit knob against the ground surface lightly
3 - Nylon line comes out
Metal blade usage
NOTE: Choose a suitable cutting attachment according to the object to be cut.
WARNING: When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy
gloves and use only proper tools and equipment to prevent injury.
1) Check the bolt to fasten the blade and be sure the bolt has no fault, and no abrasion.
2) Be sure that the blade and the holder have been fastened according to instruction and the blade
turns smoothly without abnormal noise.
WARNING
• The rotating parts fastened incorrectly may cause serious accident to the operator.
• Make sure that the blade is not bent, warped, cracked, broken or damaged.
• If the blade shows signs of damage, discard it and replace it with a new one.
3) By using the harness, hang the unit on your right side. Adjust the harness length so that the
cutting head may become parallel to the ground.
Publicidad
