Publicidad
Idiomas disponibles
Idiomas disponibles
fuel filter
Idle speed adjuster
Spark plug
Intake air cooling vent
Throttle trigger, stop
vent
Cutting parts
Angle transmission
Screws/nuts/bolts
Cutting attachment
guard
Refilling trimming line
1. For replacement line, use a diameter of 2.4mm (.095in). The spool is capable for a line up to 6m
(20ft) on the 10cm (4") head. Avoid using a larger line as it may cut down the trimming performance.
2. Pinch the slotted area on the both sides of the spool housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put one end of new line through the spool holes and
pull it until the length is equal between each part of the line.
4. Wind up the line in the correct direction as indicated on the spool.
5. Hook each end of the line in the slot on the edge of the spool, and then put the ends through the
eyelets on the housing. Make sure that the spring and the washers are in place.
6. While holding the spool against the housing, pull the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook on the housing, press the cap against the housing
until it clicks.
See adjusting idling speed
Clean and readjust plug gap
Clean
Check operation
Replace if something's wrong
Grease
Tighten/ replace
Make sure to attach
Replace carburettor if
necessary
Gap 0,6-0,7 mm,
replace if necessary
Except adjusting
screws
Publicidad
