Fermax VEO XS Guía Inicio Rápida página 8

START GUIDE FOR DUOX PLUS WIFI VEO XS MONITOR
CONTROL BUTTONS
Inductive loop label
(depending on the
model)
F2
The white line at the bottom of the icon indicates the function that is currently in effect.
Select with /
To perform a quick reboot of the terminal, press and hold the menu button for 10 seconds.
HOW TO PROGRAM WIFI VEO XS MONITOR
1. INSTALL
Monitor powered for the first time.
The blue led blinking slowly indicates that the monitor has not been
programmed.
2. ENTER PROGRAMMING MENU
Press the button to access the «programming menu».
PROGRAMMING FROM THE PANEL
PROGRAMMING MENU
Select the
Enter the calling code for this monitor from the panel (calling code for this monitor). A different
call tone sounds, confi rming the monitor´s programming. After a few seconds the monitor returns
to standby.
"The programming of the card must be done from the MASTER card". To configure the card as
MASTER, please refer to the manual of our DUOX PLUS cards Cod.970049.
2
DUOX PLUS WIFI VEO XS MONITOR
Digital menu for internal parameter settings and configuration.
(When the monitor has already been programmed)
In conversation, press to open the door.
In standby, call to guard unit (if applicable).
Auxiliary function, (contact your installer).
In standby, press and it displays the option of auto-on with
different panels. By sequentially pressing Panel 0, Panel 1,
General Panel, (depending on the available panels).
Audio activation and hang-up (hands-free functions).
Potentiometer. Ring tone volume setting.
• On standby: Melody volume.
• Conversation in progress: Upstream audio setting.
WIFI VEO XS monitor incorporates an OSD menu that
99
is managed via the monitor´s push buttons. The icons
displayed are managed with the corresponding buttons
located on the monitor.
the desired icon and confirm with
icon and confirm with
.
, (you hear a beep in the monitor).
Cod. 970165c V05_23