Skotti-grill SKOTTI Manual De Instrucciones página 13

5 THIS IS HOW YOU SET UP YOUR SKOTTI
5.1 Where to set up your Skotti?
Note the following when choosing a grilling spot:
• Skotti and its individual parts can heat up to very high temperatures, so you
should not move the grill during use. Before lighting the grill, you should consid-
er carefully if the grilling spot meets the safety requirements.
• Put Skotti on a flat and stable surface and make sure that there is enough
space (at least 5 cm) between Skotti and the surface it is on. Otherwise, unlit gas
can escape through the bottom of the grill. This can cause an explosion.
• If Skotti is sinking or leaning on sand, snow, ice, or uneven surfaces, put a
piece of wood or rock under the edges in the stands to balance it.
• Follow the assembly instructions. If Skotti is improperly set up, you place
yourself and others at an unpredictable risk.
5.2 Setting up Skotti
To set up Skotti, proceed as follows:
1. Insert the long side part (6) on the side with the Skotti
logo and the short foot part (5) with the honeycomb hole
in the connecting joint.
5
Both parts are marked with a small triangle at the con-
nection joint.
2. Plug the foot part (5) and the second long side part (6)
6
into one another at the narrow connecting joint on the
side with the Skotti lettering.
3. Slide the bottom panel (8) into the three-sided struc-
ture, pointed side down. Make sure that the hooks and
tabs are at an equal height with the slits and the smooth
edge of the panel is facing you.
4. Slide the hooks into the slits on the side panels (6).
5. Slide the tabs into the slits on the food panel (5).
This is how you set up your Skotti This is how you set up your Skotti
6. Hold the bottom panel (8) close to the foot panel (5) to
support the hooks on the side and slide both tabs at the
front of the bottom panel into the cor- responding slits
of the foot panel.
7. Take the burner pipe (3) at the squeezed end and hook
8
it into the horizontal 3 cm-long slot above the honey-
comb-shaped hole at a steep angle and with the tab
facing upward.
6
6
8. Place the burner tube (3) on the bottom part (8) with-
out exerting any force.
9. Place the radiating plates (2) over the respective
burner tube (3) to create a roof.
10. Slide the tabs of the perforated side into the two
slanted slits of the foot panel (5).
3 11. Let the baffle plate (2) rest a little on the bottom
panel (8)
12. Take the head panel (7) and slide the round end of
the burner pipe (3) through the round hole of the head
panel (7). The curvature of the head panel should be on
the inside of the grill.
13. Lift the head panel (7) and slot the two tabs on the
baffle plate (2) onto the corresponding slanted slits of
the head panel.
14. Drop the head panel (7) into place, with the slits
fitting smoothly onto the side panels (6).
✔
This produces a grill basket with equal sides.
Tip
▶ You can find the relevant video on
www.skotti-grill.com
EN
13