Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated instructions. If you
have any questions regarding your product installation call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.
Price Pfister recommends calling a professional if you are uncertain about
installing this product!
This product should be installed in accordance with all local and state plumbing
and building codes.
WARNING: This product has been designed for use with the Price
Pfister VX8 series pressure balancing valve. It will not work with any other
product. Please review the VX8 valve installation instructions before installing
this product.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found near the water meter. If you are replacing an existing unit, remove
the old unit and clean the mounting surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Philips head screwdriver
• Adjustable wrench
• Flashlight
• Cloth
Your installation will require a pipe nipple for the tub spout installation as well
as other additional tools.
4
P
N
F
J
D
C
A
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Gasket Flange
B Trim Flange
D Retainer Sleeve E Stem Extension
G Set Screw
H Hex Wrench
K Shower Arm
L Shower Head
N Knob
P Lever
If any of these items are missing, please contact Price Pfister Consumer
Service at 1-800-Pfaucet (1-800-732-8238).
• Pipe wrench
Q
L
E
K
H
G
B
M
C Washer
F Handle Hub
J Diverter Spout
M Shower Flange
Q Screws (2X)
ENGLISH
.
INSTALLATION STEPS
5
30"
Tub & Shower
5 WORK AREA INSPECTION
Verify that the hole sizes and positions in the wall are correct.
6
A
6B
B
6A
6C
6 PLASTERGUARD OPTIONS
A. For installation using plasterguard, knock out Center Section (6B) from
Plasterguard (6A). The use of plasteguard is optional for standard installations.
B. For installation without plasterguard, remove Screws (6C), and Plasterguard
(6A).
2
1
1
/
" Dia.
4
3
4
/
" Dia.
4
4" Dia. for Thin
48"
Wall Installation
Tub & Shower
8" Min.
48"
Shower Only
1
1
/
" Dia.
4
6A
30"
Shower Only
Publicidad
