Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 14)
1) Read the operating instructions.
2) Take care of the danger from catapulted
parts. Keep a safe distance.
3) Danger! Sharp blades - Switch off the engine
and pull the spark plug boot before doing any
maintenance, repair, cleaning or adjustment
work.
4) Fill with oil and fuel before starting the mower.
5) Caution: Wear ear protection and safety gog
gles.
6) Guaranteed sound power level.
7) Caution! Hot parts. Keep your distance.
8) Fill in fuel only when the engine is switched
off .
9) Risk of cut injuries. Caution: rotating cutters.
10) Starting procedure
11) Engine start/stop lever (I=Engine on; 0=Engi-
ne off )
12) Drive lever (clutch lever)
Anl_GC_PM_46_S_HW_T_SPK9.indb 21
Anl_GC_PM_46_S_HW_T_SPK9.indb 21
GB
2. Layout and items supplied
2.1 Layout (Fig. 1-12)
1a Engine start/stop lever (engine brake)
1b Drive lever (clutch lever)
2
Fuel pump (primer)
3
Top and bottom push bar
4a Debris bag
4b Level indicator
4c Mulching adapter
4d Side ejector adapter
5a Ejector fl ap
5b V-belt cover
6
Tank fi ller cap
7
Oil fi ller screw
8
Cutting height adjustment
9
Starter cable
10 2x cable clip
11 Spark plug wrench
12 2x quick-release fastener
13 4x screw (lock bolt, bottom push bar) M8
14 4x nut (hex, bottom push bar) M8
15 Front wheel with wheel mount
16 Screw (hex, wheel mount)
17 4x screw (lock bolt) M6
18 4x nut (hex) M6
19 4x washer
20 Bar
21 Front wheel locking lever
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 21 -
29.08.2019 14:02:37
29.08.2019 14:02:37