Publicidad
Idiomas disponibles
Idiomas disponibles
4.5B COOKING TIME
Press button (F) on the side to change cooking time. Display C
shows ---.
Press the button on the side to increase the value on the display.
Press the button on the side to reduce the value on the display.
For an unlimited functioning of the oven (infinite time), press the
button on the side, when the display shows value 0. The display
will then show - - -.
4.5C HUMIDIFICATION PERCENTAGE
Press the button on the side to change humidification percentage.
Press the button on the side to increase the value on the display.
Press the button on the side to reduce the value on the display.
Press again humidification button to switch off the flashing led and
store the new value for the cooking. The humidity percentage ran-
ge is: 0% - 20% - 40% - 60% - 80% - 100%
4.5D ADDING COOKING PHASES
When a cooking parameter is confirmed, led 1 next to phases but-
ton G flashes for some seconds.
During this time it is possible to add a cooking phase, pressing button G.
You can set 3 phases maximum.
4.5E STARTING A MANUAL COOKING
Pressing button S (start/stop), the preheating phase starts.
The lower display shows the word PrE.
The leds PREHEAT next to PHASE button and the led next to START/STOP but-
ton turn on.
When set preheating temperature is reached, the buzzer starts ringing to advise
the end of the preheating. On the lower display the writing "PrE" flashes to-
gether with the preheating led.
The oven will maintain the preheating temperature until the door is opened to
load the food. When the door is closed, the cooking starts with phase 1.
If the door is opened during preheating (before reaching the set preheating temperature), preheating is auto-
matically interrupted, as it is presumed the food has been loaded into the oven.
During preheating it is not possible to use automatic humidification, whereas manual humidification is available.
13
EN
Publicidad
