Beper VE.210 Manual De Instrucciones página 10

Table Fan Use instructions
PRODUCT AND ACCESSORIES Fig.A
1. Base
2. Motor
3. Grid locking hooks
4. Blade
5. Front and back grid
6. Swing on/off button
7. Adjust inclination knob
FAN ASSEMBLY Fig.B
1. Assemble the base to the motor by fixing it with the supplied screw.
2. Place the back grid in the housing and secure it with the 4 screws.
3. Place the blade and secure it with the appropriate screw.
4. Place the front grid and secure it with the screw and the locking hooks.
Important: Firmly weld all components to ensure good stability of the fan, otherwise it could oscillate
dangerously.
SPEED SELECTION
Choose the speed desired pressing on the buttons of the control panels.
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
HEAD INCLINATION
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body, unscrew the adjust inclination knob and change the inclination of the fan as desired and
screw the knob strongly.
Attention : do not try to force the inclination position in order to avoid any failure.
SWING
It is possible to activate or disconnect the swing of the fan, by touching appropriate button. Swing allow to provide
the air uniformly.
To activate the swing push the button down until completely blocked ; the head fan turns automatically from right
to left.
To disconnect the swing raise the button completely.
CLEANING
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not allow water or other liquids to penetrate in the fan, in order to protect it.
After cleaning, dry every parts before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.
TECHNICAL DATA
Power : 35W
Power supply. : 230V~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
10