Tecfrigo Isola Murale 4 M Dry Instalación Y Uso página 6

Operator's guide:
1. Unpacking instructions
2. Opening the protective cover
3. Cleaning the internal basin
I
4. Cleaning the cover and external parts
5. Holders for containers
UK
6. Plate-holder
7. Connection to the mains
D
8. Controls
9. Checking correct operation
10. Cleaning the basin
E
11. Replacement of the lamps
F
!
WARNINGS (Pag.46)
It is most important that this instruction booklet is kept together with the appliance both for future
NL
reference and for reasons of safety. 1. Adults should operate this appliance only. Do not allow children
to use the controls or play with it. . It is forbidden to modify in any way the main functions and
P
characteristics of this appliance. . The electrical installation of the appliance should be carried out by a
qualified electrician or other competent person. . Never attempt to carry out repairs unassisted. Inexpert
S
repairs can cause serious damage and malfunction. . Assistance has to be provided by an authorized
engineer only. Always use original spare parts. . This appliance is not suitable for the storage of basic
commodities not including food-stuffs. . The manufacturers of this appliance accept no responsibility for
DK
the consequences of misuse in contravention of these safety instructions. It further reserves the right to
carry out improvements without prior notice. 8. Avoid installing the cabinet directly in line with sunlight.
FIN
9 . Nevere install the appliance near sources of heat, such as radiators, stoves, etc.
ventilation grills free from obstruction for at least 30 cm.
B
shelves and grills do not hang over the edges.
ice to form on the evaporator, we recommend stopping the compressor and placing the goods in special
GR
refrigerated containers, kept at the same temperature, until defrosting is completed;if this is not carried
out the compressor will continue to operate leading to a wasteful consumption of electricity and poor
CZ
performance.
least 10 cm.
EE
!
Our products are for internal use only do not install outside restaurants, shops
LV
LT
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards.
H
WOODEN CRATE 1b
between the appliance and pallet or crate. . Lift the appliance. . Remove the pallet or crate. . Place
M
the appliance on a flat, level surface.
it. . Sort out the packaging materials in order to facilitate disposal. . The appliance can be locked in 7
PL
place by engaging the wheel brakes (see fig. 1).
2. OPENING THE PROTECTIVE COVER
SK
1. Plug the machine into the power supply socket, as described in Chapter 7.
electric lifting system
SLO
heating lamps off 15 minutes before lowering the cover (see fig. 2).
3. CLEANING THE INTERNAL BASIN
1. Remove the protective film from the stainless steel parts. . Clean the basin with a soft,
SPONGE DO NOT USE WATER.
4. CLEANING THE COVER AND EXTERNAL PARTS
1. Never use detergents containing alcohol or solvents which would irremediably damage the cover,
compromising its transparency.
concerned, use proprietary detergents especially designed for wooden surfaces, which are water-based
and do not contain solvents. . Dry with a clean cloth.
5. HOLDERS FOR CONTAINERS
1 . Remove the protection film from the holders. . Place the longer holders on the long sides of the basin.
3. Place the shorter holders on the special slots on the longer holders. Different arrangements are
available for different container sizes and positions
requirements (see fig. 3).
6. PLATE-HOLDER (OPTIONAL)
Fasten the shelves to the outer cabinet, by tightening the screws inside the holes provided for this
purpose (see fig. 4).
2
3
7
13
. If the appliance is not working and unused,it is indispensable to keep the door open at
N.B.: turn the heated shelves and heating lamps off 15 minutes before lowering the cover
. Remove the nails from the wooden crate with care. . Insert forks of forklift truck
6.
(A) to position II until the cover is fully open.
2. Use only a soft damp sponge. . As far as the wooden surfaces are
4
Operator's guide
12. Replacing the mirror
Maintenance manual (Page 48):
1. Replacement of the cover's lifting motor
2. Replacement of the resistors
3. Wiring diagram diagram of refrigeration unit
4
5
6
11
. Ensure that the products displayed on the
12 . If damp air or products to be refrigerated should cause
3 4
Make sure there is nothing left in the package before disposing of
2
3
2
. 4
. Position the containers in accordance to your
6
10 . Keep the
2
8
2. Turn the switch of the
3. N.B. : turn the heated shelves and
DAMP
5