Connect Discharge Hose (Optional) - Briggs & Stratton 073000 Manual Del Operario

Connect Suction Hose to Strainer Basket
Slide hose clamp over hose. Connect open end of
suction hose to strainer hose barb (Figure 6). Tighten
hose clamp securely using a standard 1/4" (6mm)
screwdriver.
Figure 6 - Connect Suction Hose to Strainer Hose Barb

Connect Discharge Hose (Optional)

1" Discharge Hose Assembly
If desired, purchase a commercially available hose
(1" inside diameter) and attach to water pump as
described.
1. Slide barb cuff over hose barb. Insert rubber seal
into end of barb cuff (see Figure 3, earlier).
2. Screw hose barb assembly onto pump in
clockwise rotation until hose barb assembly is
tightened securely (Figure 7).
Figure 7 - Connect Hose Barb to Pump
3. Slide hose clamp over end of discharge hose. Slide
discharge hose onto hose barb (Figure 8). Tighten
hose clamp securely using a standard 1/4" (6mm)
screwdriver.
Figure 8 - Connect Discharge Hose to Hose Barb
Garden Hose Discharge Assembly
1. Insert rubber seal into end of garden hose
adapter. Attach supplied 1" garden hose adapter
onto pump discharge port. Finger tighten in
clockwise rotation (Figure 9).
Figure 9 - Connect Garden Hose Adapter to Discharge
Port
2. Attach garden hose to adapter, turning in
clockwise rotation.
8
ASSEMBLY