Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly method
If with grab bars, find the following accessories:
Type O screw*4
Wrench*1
Nut washer*4
Handrail vertical rod*2
Handrail L rods*2
Handrail crossbar*1
Fix the O-type screw into the hole of the leg. Put the upright rod into the position of
the three-shaped screw and plastic according to the angle shown in the figure.
Tighten the upright rod on one side, then align the L-shaped upright rod with the
upright rod and buckle it. Install the other side of the pole. After installation, do not
fix the O-type screws on the feet first, buckle the marbles on the cross bar into the
holes of the L-type poles on both sides, then fasten the screws on the feet.
Publicidad
