Publicidad
Idiomas disponibles
Idiomas disponibles
REFRIGERATOR INSTALLATION
Remove Packaging Materials
IMPORTANT:
Do not remove any permanent instruction labels or the data label on your refrigerator.
•
Remove tape and glue from your
•
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with
warm water and dry with a soft cloth.
•
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your refrigerator.
NOTICE:
LOSS OR SPOILAGE OF PRODUCTS IN YOUR REFRIGERATOR IS NOT COVERED BY WARRANTY. IN ADDITION
TO FOLLOWING RECOMMENDED INSTALLATION PROCEDURES. PLEASE RUN THE REFRIGERATOR 24 HOURS
PRIOR TO USAGE.
Location Requirements
•
Refrigerators represented in this manual are intended for indoor use only.
•
Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents as a
fully loaded unit can weigh as much as 1500 pounds.
•
Reinforce the floor as necessary to provide for maximum loading.
•
For the most efficient refrigeration, be sure to provide good air circulation inside and out.
Inside cabinet:
Do not pack the units so full that air cannot circulate. The refrigerated air is discharged at the top rear of the unit. It is
important to allow for proper air flow from the top rear to the bottom of the unit. Obstructions to this air flow can cause
evaporator coil freeze ups and loss of temperature or overflow of water from the evaporator drain pan. The shelves have
a rear turn up on them to prevent this. However, bags and other items can still be located to the far rear of the cabinet.
is brought into the evaporator coil with fans mounted to the front of the coil.
Outside cabinet:
Be sure that the unit has access to ample air. Avoid hot corners and locations near stoves and ovens.
It is recommended that the unit be installed no closer than 2" (51mm) from any wall, a max door swing clearance of 60.5
in. (1537mm) and with at least a 12" (305mm) of clear space above the unit.
Excessive Weight Hazard
Use two or more persons to move and install refrigerators.
Failure to do so may result in back or other injury.
refrigerator
before using.
WARNING
Page 10 of 67
Air
Publicidad
