Descargar Imprimir esta página

Maxx Cold SELECT MXSR-23FD Manual De Instrucciones, Instalación Y Mantenimiento página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFEGUARDS
Before
the
described in this manual, so read the manual carefully. We strongly recommend that
you have a professional install your new machine. The warranty may be affected or
voided by an incorrect installation. To reduce the risk of fire, electrical shock or
injury when using the refrigerator, follow basic precautions, including the following:
DANGER
It is recommended that a separate circuit, serving only your refrigerator, be provided. Use receptacles that cannot
be turned off by a switch or pull chain.
Please ensure that the required voltage is being supplied at all times.
The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate over-current
protection.
Ensure unit is not resting on or against the electrical cord.
Do not connect or disconnect the electric plug when your hands are wet.
Never unplug the
refrigerator
the outlet.
Never clean
refrigerator
liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.
Before proceeding with cleaning and maintenance operations, make sure the power line of the unit is disconnected.
Unplug the
refrigerator
shock or death.
If the unit is not in use for a long period of time, best to unplug the unit from the outlet.
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could cause damage to
the compressor.
If the power cuts off, wait at least 5 minutes before turning the unit on to avoid damage to the compressor.
Do not attempt to repair or replace any part of your
qualified technician should do all other servicing or repairs.
WARNING
Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury.
This refrigerator must be properly installed and located in accordance with the Installation Instructions before it is
used.
Do not touch the cold surfaces in the refrigerator compartment when hands are damp or wet. Skin may stick to these
extremely cold surfaces.
Setting temperature controls to the ZERO (0) position does not remove power to the light circuit, perimeter heaters, or
evaporator fans.
To ensure proper ventilation for your refrigerator, choose a well-ventilated area with temperatures above 50ºF
(10ºC) and below 100ºF (38ºC). This unit MUST be installed in an area protected from the elements, such as
wind, rain, water spray or drips.
The
refrigerator
should not be located next to ovens, grills or other sources of high heat.
It is important for the
Remove the packing materials and clean the
Do not use this apparatus for other than its intended purpose.
refrigerator
is used, it must be properly positioned and installed as
by pulling on the power cord. Always grip the plug firmly and pull straight out from
parts with flammable fluids. Do not store or use gasoline or other flammable vapors and
or disconnect power before cleaning or servicing. Failure to do so can result in electrical
refrigerator
to be level for proper operation. You may need to make adjustments to level it.
refrigerator
unless it is specifically recommended in this manual. A
refrigerator
before using.
Page 5 of 67

Publicidad

loading