Keep out of the reach of children under five years of age.
Should not insert fingers between the lifting device components - risk of injury or entrapment.
Keep extreme caution while unfolding / folding the lifting device. Lack of attention may result in finger entrapment.
Always maneuvers the lifting device with the handle provided.
Do not use a sling that is not recommended for the lift.
Only trained and qualified caregivers should transfer a person.
Lifting device is designed for transferring patients only. Do not use the lifting device for any other purpose.
Before each patient lifting, make sure that base legs were blocked in maximum wide position.
While moving the patient, should bypass obstacles at safe distance, which might cause the lifting device to tip over.
Before each lifting device usage, make sure that slings are in good condition. Usage slings showing signs of damage is
forbidden.
Before using lifting device, should charge the battery for about 6-8 hours. Make sure, the red warming lights is off.
If any parts are damaged, broken, worn or missing, contact the dealer.
MOUNTING
I. Assembly guide
1. Install the column
Fig. 2. Scheme of mounting the lifting column.
Remove the device and spare parts from the package. Loosen the jam nut and bolt, then raise the frame and align the holes
in parallel. Tighten the screws and tighten the nut properly (make sure there is no movement at the frame).
ATTENTION: When mounting the lifting column, avoid standing under it, failure to do so may result in accidental fall Of the
column and risk of injury.
2. Hoist Arm and Powered Actuator
Fig. 3. Installation of lift arm
Align the bracket with the mast mounting hole, screw in the bolt and washer, install the bottom of the actuator and column
in place, and finally install the electric actuator and bracket, tighten all nuts.
3. Install the Controller
Fig. 4. Controller installation scheme
DMI-F-04_Annexe 3_Notice 1.0 RAJOUTER CODE ERREUR
14