Descargar Imprimir esta página

Infiniton SD-8NDP Manual De Instrucciones página 39

Ocultar thumbs Ver también para SD-8NDP:

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning & Maintenance
WARNING! Before cleaning, unplug the power plug first; do not connect or disconnect the power
plug with wet hands, as there is a risk of electric shock and injury.
Do not spill water directly on the appliance, thus avoiding rust, electricity leakage and accidents.
Regular cleaning of this appliance helps to prolong its life.
External cleaning
Clean dust accumulated on the surface of the appliance frequently.
After using detergent, be sure to rinse it with clean water and then wipe it dry with a cloth.
Note: Never use metal scouring pads as this may damage painted, chrome and plastic surfaces.
WARNING! Do not use bristle brushes, wire brushes, detergent, soap powder, alkaline detergent,
benzene, gasoline, acid, hot water and other corrosive or soluble elements to clean the surface of the
appliance, door gasket, plastic decorative parts, etc. to avoid damage. Carefully dry the door gasket,
clean the groove with a wooden stick wrapped with cotton thread.
Cleaning the door
Clean the glass and door gasket after each wash to remove
possible lint and/or detergent/softener residues, as leaks may
occur.
If any rust stains are found inside the drum, they should be
removed with non-chlorine detergent.
Cleaning the water tank
Pull out and hold the water container with both hands.
Tilt the water container, pour the condensed water into the sink.
Install the water container.
Note:
Empty the water container after each use. Once the water container is comple-
tely full, the programme will stop and the word "Ful" will appear on the display.
After emptying the container, the dryer can be restarted by pressing the Start /
Pause button.
- Do not drink the condensed water.
- Do not use the dryer without the water container.
Cleaning the filters
This tumble dryer has a main lint filter in the door.
Be sure to clean the door filter after each cycle.
Note:
In order for the double-layer filter to close smoothly, it is necessary to align the
arrows at both ends, as well as the centre slot and the side slot.
slot.
Cleaning the door filter
1. Open the door.
2. Remove the door filter.
3. Open the filter and remove the lint from the filter, you can clean it under running
water.
4. Dry the door filter thoroughly before reinstalling it.
Observe the correct orientation before inserting the door filter.
42
English
infiniton.es

Publicidad

loading

Este manual también es adecuado para:

8436546192282