Publicidad
Idiomas disponibles
Idiomas disponibles
EN
BATTERY IS TOO WARM (REMOVE
FOR APPROX. 30 MINUTES TO AL-
LOW TO COOL)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
Incorrect Defect Note:
1. Put the battery pack into the charger.
•
If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
•
If the status LED blinks GREEN, the battery pack is
good.
•
If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
•
If the status LED shows blinks GREEN, the battery
pack is good.
•
If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
Low voltage charging
•
It can take 20 hours to fully charge the battery if the
battery stored with no little no charger for a long period
of time.
•
If the battery is not used for a long time, the charger will
go into the recovery mode, which needs to get 20 hours to
fully charge the battery.
•
It can extend the life of the battery. When it is fully
charged, the next charge will get back to standard
charging.
6.2
EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6° C to 40° C (42.8° F to 104°
F) .
If you attempt to charge the battery pack in a warm or hot
environment, and the charger LED light is red, remove the
battery pack and let the battery cool for approximately 30
minutes.
6.3
MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
RED
RED
BLINKING
WARNING
English
2. Use 2 wood screws to attach the charger on the wood
studs.
3. For chargerGCH8020: Drill two holes 92.3mm on center
ensuring they are level. For charger 2901402/ CAB813:
Drill two holes 114.3mm on center ensuring they are
level.
4. Use wall anchors and screws to attach the charger to the
drywall.
GCH8020
2901402/ CAB813
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
7
MAINTENANCE
7.1
CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or submerge in water.
•
Clear the unwanted material out of the air vent with a
vacuum.
•
Clean housing and the plastic components with a soft, dry
cloth.
6
NOTE
NOTE
Publicidad
