Tascam BD-MP1 Manual Del Usuario página 26

Turning the unit on and off
NOTE
When this unit is connected by a power cord and electricity
is supplied from an outlet, it will automatically start up. (This
will also occur when power is restored after a power outage
or other interruption to the power supply.)
If the STANDBY/ON indicator on the front of the unit lights red,
button or the remote control STANDBY/ON button.
press the
HELLO
Startup screen
BD
BDMV
Operation screen
After the unit starts and the startup screen is shown, the
operation screen will appear on the display.
Turning the unit off
button or the remote control STANDBY/ON button
Press the
to turn the unit off.
ATTENTION
Do not turn the power off or disconnect the power cord
when the unit is operating (including playing back or writing
data to a USB flash drive). Doing so could damage the unit.
Loading and removing discs
Loading discs
Press the OPEN/CLOSE ( - ) button on the main unit or remote
control.
Open the disc tray and place the disc on it with the label side up.
Press the OPEN/CLOSE (-) button again to close the disc tray.
After loading a disc, the unit will read its information and show
the media type on the display.
NOTE
i When the disc tray is open, "
display. When the disc tray is open, "
the display.
i If a disc other than a playable CD is inserted or a disc is
inserted upside down, the unit will automatically eject it.
Ejecting discs
Press the OPEN/CLOSE ( - ) button on the main unit or remote
control.
After the disc tray opens, pick the disc up by its center and
remove it.
NOTE
The OPEN/CLOSE ( - ) button functions when the unit is
turned on.
26
TASCAM BD-MP1
USB
" will appear on the
OPEN
" will appear on
CLOSE
Inserting and removing SD cards
Inserting SD cards
Insert an SD card into the SD card slot on the front of the unit to
enable playback.
TIP
SD cards can be inserted whether or not the unit is on or off.
i Inserted SD cards with the correct orientation.
i The label should be up and the connector should be
inserted toward the back.
Removing SD cards
Turn the unit off or stop operation before removing an SD card.
ATTENTION
Do not remove an SD card when the unit is operating
(playing back an SD card). Doing so could cause proper
dubbing to fail, data to be lost, and sudden loud noises from
monitoring equipment, which might damage the equipment,
harm hearing or cause other trouble.
1. Press the SD card in gently to make it to come forward.
2. Pull the SD card out by hand.
SD card write protection switches
SD cards have write-protection switches that prevent writing
new data to them.
Connecting and disconnecting USB
flash drives
Connecting USB flash drives
Connect a USB flash drive to the USB port on the front or back of
the unit to enable playback.
TIP
You can connect a USB flash drive when the unit is on or off.
Disconnecting USB flash drives
Turn the unit off or stop operation before disconnecting a USB
flash drive.
ATTENTION
Never disconnect a USB flash drive when the unit is operating
(including playing back or writing data to the USB flash
drive). Doing so could cause the loss of data or damage the
unit.