HOMCOM Mclaren ARTURA JL211 Manual Del Usuario página 11

Using the 2.4G remote control:
Installing or changing batteries: To open, push down on the battery cover located
on the back of the remote controller. Use two AAA batteries, ensuring they match
the polarity (+ and -) correctly. Close the battery cover.
First use: Pairing the ride-on with the remote control:
● Hold the forward and backward keys for three seconds - the speed indicator
will flash.
● Turn on the car's power switch. If the pairing is successful, the indicator will
turn into a long, bright light.
● If the indicator does not light up, turn off the car's power and repeat the steps.
● The vehicle must be paired with the remote control before use, especially
when replacing batteries.
General Use
Speed gear button (S button):
- This button selects one of three speeds.
- If you choose the low speed, the 'speed indicator 1 LED' light will turn on.
- If you choose the middle speed, the 'speed indicator 2 LED' light will turn on.
- If you choose the high speed, the 'speed indicator 3 LED' light will turn on.
Note: Every speed has a slow start.
Stop button (P button):
- This will stop the vehicle. The speed indicator flashes when pressing this
button.
Directional buttons:
Forward: Moves the vehicle forward.
Backwards: Moves the vehicle backwards.
Left: Turns the vehicle left.
Right: Turns the vehicle right.
11
10