Publicidad
CD PELAYER
CD Player
Playing a CD
This CD-player can play Audio Discs, CD-R
andCD-Rewritable.Do not try to playCD-ROM,
CDi, VCD, DVD or computer CD.
1. Adjust the source selector to CD.
Display: shows "cd" Briefly.
2. To open the CD door, press the CD door at
the edge marked OPEN.
3. Insert a CD , CD-R or CD-RW with the
printed side facing up and press the CD door
gently close.
4. Press PLAY/PAUSE on the set to start play
back.
5. To pause playback press PLAY / PAUSE to
resume, press PLAY/PAUSE again.
6. To stop CD playback, press STOP
.
Note: CD play will also stop when:
- you open the CD compartment;
- you select RADIO sound source;
- the CD has reached to the end.
During playback you can use
or
to select a
particular track.
If you have selected a track number in the stop
or pause position , press PLAY/PAUSE to
start playback.
Press
once briefly for the next track, or
press repeatedly until the desired track number
appears in the display.
Press
once briefly to return to the beginning
of a current track.
Press
more than once briefly for a previous
track.
Different play modes:
REPEAT
- plays the current track continuously
REPEAT ALL
- plays the entire CD continuously
EN-7
Programming track numbers
You may store up to20 tracks in the desired
sequence . If you like, store any track more
than once.
1. In the PROG mode, press
or
for your
desired track.
2. When your chosen track number appears,
press PROG once to store the track.the
display shows prog and prog brieflyfollowed
by your selected track number.
3. Repeat steps 1to 2 to select and store all
desired tracks in this way.
4. To play your program, press PLAY/PAUSE .
Reviewing your set program
After playing at least one programmed track,
press
or
, the display will show your
stored track numbers
Erasing a program
You can erase the contents of the memory by:
- opening the CD door;
- slide the function selector to OFF source.
MAINTENANCE & SAFETY
Precautions & General Maintenance
Place the set on a hard and flat surface so that the
system does not tilt.
Do not expose the set, batteries or CDs to
humidity,rain,sand or excessive heat caused by
heating equipment or direct sunlight.
Do not cover the set. Adequate ventilation
with a minimum gap of 6 inches between the
ventilation holes and surrounding surfaces is
necessary to prevent heat build-up.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled
or lubricated.
To clean the set, use a soft dry cloth. Do not
use any cleaning agents containing alcohol,
ammonia,benzene or abrasives as these may
harm the housing.
CD player and CD handling
The lens of the CD player should never betouched!
Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD
player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a
warm environment until the moisture evaporates.
Always close the CD door to keep the CD compartment dust-free. To clean,dust the compartment
with a soft dry cloth.
To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not
use cleaning agents as they may damage the disc.
Never write on a CD or attach any stickers to it.
X
EN-8
Publicidad
