Haier AS20S2SF2FA-3 Manual De Instrucciones página 7

Operation
Steri Clean Operation
The Steri Clean 56°C Function can be controlled
only by the App hOn.
Introduction to Steri Clean
1st-stage: Self Clean to remove dirt away (It freezes the
evaporator with moisture in the air, and removes away dirt
in melting. The hydrophilic aluminum coating with smaller
angel (ɑ≈5°） helps increase water drainage efficiency.)
2nd-stage: 56℃ high temperature sterilization (It
utilizes smart temperature monitoring and frequency
control technology to adjust the compressor operation, so
that we maintain the evaporator temperature at high
temperature for over 30mins to kill bacteria and virus
inside the air conditioner.)
3rd-stage: Rapid evaporator cooling to enhance the
sterilization performance. The foil surface is coated with
silver nanoparticles whose anti-bacterial efficiency is up to
99%.
Attention:
1.The function lasts 60-80 minutes.
out during the process when evaporator is heated to 56℃
or maintains at 56℃ in summer.
2.The function may result in the changes of room air
temperature in winter.
3.When outdoor ambient temperature is above 36℃, the
function cannot be performed. Instead, Self Clean function
will be turned on and lasts 21mins when Steri Clean is
turned on.
Hot air may come
SELF-CLEAN Operation
◆Functional description
the purpose of this function is to clean the evaporator.
◆Entry and exit：
If this function is needed, please check in hOn APP.
Press SELF CLEAN button to enter this function, then
it will display "CL" on the panel of the indoor unit and also
on the remote controller. Maximum running time not more
than 21 minutes, this function will exit automatically with the
" Pi " sound twice, then the unit return to original state.
Under operation process of SELF CLEAN, press the button
repeatedly is invalid and cannot exit, please press the
"power" button or swift to other mode to exit.
◆ Note:
1.This function is invalid in timer / sleep mode.
2.After this mode starts, the air volume may reduce or
even have no airflow,or even cold airflow blowing.
3.It is normal if the unit make some sound like expand with
heat and contract with cold.
4. The "CL" display time may last differently on the remote
controller and panel.
5.If the outside ambient temperature below zero, error
code "F25 "may be occurred during self-cleaning operation ,
which is normal protection, please turn off the power
and to restart after 10 seconds .
6.The best condition to run this mode: the temperature is
20℃~27℃ and the humidity is 35％~60％ in the door,
the temperature is 25℃~38℃（cooling season）out the
door.
7.It is hard to frost if the air is too dry(humidity＜20%). and
if the humidity is too high(humidity＞70%).the condensate
water may increase, which may move away some frost.
:
4