VICSONIC S7 Manual Del Usuario página 8

Instructions for use
Instructions
1. As shown in the figure below, a variety of combination modes can be realized by matching
the host and accessories. After the machine is assembled, press the switch button to start
the machine and start working, and press it again to shut down the machine.
2 The default setting is automatic mode when starting up, as shown in the figure below. Press
the 7d button in the power-on state to switch to manual gear. After switching, it defaults to
low manual gear. Tap 7e "+" to adjust upshift, conversely tap 7c "-" to adjust downshift.
Press the 7d button again to switch to automatic mode.
Notice:
1. The battery pack indicator light is always on when the vacuum cleaner is operating
normally. When the battery power is low, the indicator light on the battery pack will
continue to flash until it automatically shuts down. Please charge in time.
2. The electric floor brush will rotate at a high speed when assisting in vacuuming. At this
time, please do not stay on the same place on the floor for too long, otherwise it may
damage the floor surface.
3. The electric floor brush end is equipped with overcurrent protection function. When the
electric floor brush is entangled or blocked, the preset protection program will cut off the
power. In this case, the electric floor brush will stop and the LED screen will display E3. In
this case, please turn off the power of the machine immediately, remove the battery pack,
check and clean the electric floor brush. After removing the blockage, please reload the
battery pack and start the machine to use it again.
4. The machine is equipped with an infrared dust sensor. In the automatic gear, the power of
the machine can be adjusted in real time according to the detection result of the amount of
dust. However, long-term use may cause dust to accumulate and affect the normal
operation of the dust sensor. If the LED screen displays E1, please turn off the power in
time, remove the battery pack and dust cup, and clean the dust sensor. After reinstalling
the battery pack and dust cup, start the machine and you can use it again.
IR sensor
6