VICSONIC S7 Manual Del Usuario página 9

Cleaning and maintenance
Cleaning the dust cup:
1. Turn off the power and remove the accessories.
2. As shown in Figure 4, align the bottom of the dust collection cup of the main unit with the
trash can, and press the open button on the dust collection cup to collect the dust. The
bottom cover of the cup opens automatically, gently shake to empty the dust in the dust
collection cup, close the bottom cover and lock it tightly.
Note: When the dust in the dust collecting cup reaches the marked maximum
position, please clean the dust collecting cup in time.
Dust Cup Open Button
Picture 4
1. As shown in Figure 5, press the dust cup release button and
remove the dust cup assembly.
2. As shown in Figure 6, remove the hepa and rotate the filter
assembly counterclockwise.
3. As shown in Figure 7, take the filter out of the dust cup.
4. Clean the hepa, filter and dust cup with a soft brush and
reinstall them in the reverse order. Incorrect installation will
result in reduced suction!
5. In order to maintain the best cleaning performance, it is
recommended to clean it every 4-6 times (depending on
actual usage).
Removal of foreign body blockage
When the air duct of the machine is entangled and blocked by foreign matter, the protection
program will cut off the power supply of the electric floor brush, and the electric floor brush will
stop rotating. At this time, please turn off the machine switch immediately, check and clean the
electric floor brush or extension pipe, remove the blockage and cool down for a period of time
before using it again.
Removal of foreign objects that are blocked by the extension tube:
Remove the extension tube, check and unblock it, and then reinstall it.
Removal of foreign objects blocked by the electric floor brush:
Refer to "Cleaning of Electric Floor Brush".
Dust cup release button
Picture 5
7
HEPA
Picture 6
HEPA
Honeycomb filter
Dust cup
Picture 7