LF Harbor Breeze LWS2812B Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Secure the crossbar assembly (A) to the outlet box
(not included) with outlet box screws (BB). Tighten
until snug.
Note: The preassembled mounting screws on the
crossbar should protrude outward.
Hardware Used
Outlet Box
BB
Screw
2. Remove mounting balls from mounting screws
on crossbar assembly (A). Temporarily fit fixture
body (B) over the mounting screws (A) and
secure with mounting balls.
Note: The backplate of the fixture body (B)
should be snug against the wall and the
mounting balls. If not, adjust the length of the
mounting screws by unscrewing the
preassembled hex nut and then screwing the
mounting screw in or out of the crossbar until the
correct length is achieved.
Once the backplate of fixture body (B) is secure,
remove the mounting balls and fixture body (B)
and proceed to step 3.
3. Attach ground fixture wire to either the green ground
screws preassembled on the crossbar assembly (A)
or to the ground wire in the outlet box (usually
GREEN or BARE). If attaching fixture ground wire to
the crossbar assembly (A), it is imperative the outlet
box in your home be properly grounded. Connect the
neutral WHITE or RIBBED fixture wire to the neutral
(usually WHITE) wire from the outlet box. Connect
the hot BLACK or SMOOTH fixture wire to the hot
(usually BLACK) wire from the outlet box. Fasten
wires together with wire connectors (AA) and tightly
wrap wire connectors (AA) with electrical tape (not
included).
Hardware Used
Wire
AA
Connector
1
x 2
2
Outlet Box
3
From Outlet Box
From Outlet Box
From Outlet Box
From Outlet Box
x 3
4
Outlet Box
A
Mounting Screw
Mounting Ball
A
Hex Nut
AA
Ribbed Side
White Wire
From Fixture
Smooth Side
Black Wire
From Fixture
Bare, or Green
Bare, or Green
Ground Wire
Fixture Ground Wire
OR
Bare, or Green
Ground Wire
Green Ground Screw
I
BB
B
White or
Black or