Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Make sure exterior wall surface and fixture
backplate are free of dirt. Using silicone sealer
(not included), start on one side of fixture
backplate and follow contour, where the fixture
backplate meets the exterior wall surface upward.
Proceed to seal over top of backplate and down
other side.
NOTE: Do not seal bottom of fixture backplate to
ensure proper moisture drainage.
CARE AND MAINTENANCE
• Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives
to clean fixture as they may damage the finish.
• Bulb Replacement: Install a 60-watt max. medium-base incandescent bulb or a 13-watt max. spring
elf-ballasted standard-base CFL.
TROUBLESHOOTING
PROBLEM
Bulbs will not light.
Fuse blows or the
circuit breaker trips
when light is turned
on.
POSSIBLE CAUSE
1. Bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire is
grounding out.
7
Fixture
Backplate
Exterior Wall
Surface
CORRECTIVE ACTION
1. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace the switch.
Check wire connection.
6
Silicone Sealer
Publicidad
