Ryobi PCL465 Manual Del Operador página 6

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
„ Polishing and buffing cars, boats, RVs, personal water-
craft, motorcycles, hardwood floors, and large furniture.
WARNING:
Battery tools are always in operating condition. Therefore,
the switch should always be in the OFF ( O ) position
when not in use or carrying at your side, when installing
or removing the battery pack, and when installing or
removing accessories.
OPERATION
TURNING THE BUFFER / POLISHER ON/OFF
See Figure 1, page 10.
„ To start the buffer/polisher, place the power switch in the
on position by moving dial to settings 1-5.
„ To stop the buffer/polisher, place the power switch in the
OFF ( O ) position.
The tool's rotating base moves in random orbital motion.
The orbit diameter is 1/2 in (12mm).
VARIABLE SPEED DIAL
See Figure 1, page 10.
The variable speed dial is located on the top of the tool and
allows the buffer to operate at different speeds. The speed
can be adjusted only during operation. Select the speeds
designated on the unit for the following applications.
Application ........................................................Speeds 1-3
Buffing ...............................................................Speeds 3-5
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 10.
„ To install: Make sure the power switch is in the OFF ( O )
position.
„ Place the battery pack in the tool.
„ Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
tool before beginning operation.
„ To remove: Turn the switch off and depress the latches.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.
PREPARE THE SURFACE
For best results, the surface should be clean and dry. Most
high-gloss surfaces can be cleaned with a mild soap and
water solution. For removal of stubborn dirt such as road
tar, grease, and bug stains, you can use a mild ammonia
solution such as that used in glass cleaners. To remove dirt
that will not come free from topical washing, treat surface
using a clay bar before buffing. Before using any cleaning
product, check the label for recommended applications and
follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the surface.
Do not use any type of abrasive cleanser as it may damage
or scratch the surface.
6 – English