Replacing The Fuses - EGAmaster Egatronik 51267 Manual De Instrucciones

compartment, and separate the battery compartment from the case bottom.
4. Remove the battery from the battery compartment.
5. Replace the battery with a new 9V battery (NEDA 1604 or 6F22 or 006P).
6. Rejoin the battery compartment and the case bottom, and install the screw and rubber feet.
C.

Replacing the Fuses

Warning!
To avoid electrical shock or arc blast, or personal injury or damage to the Meter, use specified
fuses ONLY in accordance with the following procedure.
1. Disconnect the connection between the testing leads and the circuit under test, and remove
the testing leads away from the input terminals of the Meter.
2. Turn the Meter OFF.
3. Remove the rubber feet and screws from the case bottom, and separate the case bottom from
the case top.
4. Remove the fuse by gently prying one end loose, and then take out the fuse from its bracket.
5. Install ONLY replacement fuses with the identical type and specification as follows and make
sure the fuse is fixed firmly in the bracket.
0.5A. 250V fast type fuse, Ø5x20mm.
6. Rejoin the case bottom and the case top, and install the screw and rubber feet.
Replacement of fuses is seldom required. Burning of a fuse always results from the improper
operation.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the device being
incorrectly used or, applied for a purpose for whith it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must
be collected and arranged separately. If you have to throw them out, please, do not use the usual
rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the device owner 12 months against any manufacture defect.
This guarantee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
36
NOTES
GUARANTEE