Bimar DEU311 Manual De Instrucciones página 16

Fax +32 030 9904733

Moreover, the device is equipped with a tank to collect water; the tank must always be fully inserted
or the device will not work and it must be emptied when it is full of water. The device is also
equipped with a hole for continuous drainage, with a rubber attachment, the tube (12 mm internal
diameter) must have the proper slope to drain continuously, see section: continuous drain to the
outside.
USE
Before each use, check that the equipment is in good condition, that the wiring is not damaged: if the
power cable is damaged, it must be replaced by the manufacturer or its technical assistance centre or
by someone who is similarly qualified, in order to prevent any risks. Warning: before the
assembling, disassembling and cleaning of the device, make sure it is disconnected from the mains.
There may be a bit of water left over inside the tank from any testing previously performed.

Make sure that if the water is discharged into the tank (not via emptying continuously towards the
outside), check that the cap (7) is placed properly.

Insert the plug into the socket, the "

Press " ".

When pulling out the water collection tank, the dehumidifier will switch off; as soon as the tank is
replaced, the device will automatically restart.

Keep doors and windows tightly sealed to enhance the effect of dehumidification, other than
when necessary to ventilate the room.

To turn off the unit, press "
If the device is not in use for long periods of time, remove the plug from the plug point.
Emptying water tank manually
When the tank is full, the dehumidifier will switch off and the "
indicator light will come on and the device will remain on standby;
turn off the device with the "
mains, remove the tank and drain it into a sink or a bathtub. After
operation, replace the tank properly, plug the device into the mains
and turn it on using the "
Continuous drain to the outside.

The device can be operated continuously
for long periods of time without the
periodic emptying of the tank by means of
a discharge tube (not supplied, 10).

Check that the dehumidifier is switched off
and remove the plug from the mains.

Remove the rubber cap supplied (8) at the
back from the outlet hole of the outlet
connector (9).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" .
" and remove the plug from the mains.
"button, remove the plug from the
" button.
16
Assembly page 16/51
"