Descargar Imprimir esta página

Bestron DFS45SCO Manual Del Usuario página 28

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
OPERATION - Ventilate
5
1. Set the fan on the floor, on a level surface.
2. Adjust the stand to the required height. To do so, loosen the height lock
(anticlockwise). Adjust the stand to the required height, and tighten the
height lock (by turning it clockwise).
3. Tilt the fan to the required angle. You can set the fan:
a. to blow horizontally (position a) or angled slightly downwards (position
b). Tilt the ventilator housing and motor housing to the required angle.
b. to oscillate from left to right (with a sweep of 90°). This will ventilate
much of the room. Press the oscillation button on the motor housing
fully in.
c. remain in the same position whilst the fan is turning. This will ventilate
one area. Pull out the oscillation button until you hear it click.
4. Put the plug into the wall socket.
5. Switch on the fan by turning the speed dial.
a. Position 'I': the fan operates at low speed.
b. Position 'II': the fan operates at normal speed.
c. Position 'III': the fan operates at high speed.
6. Stop the fan by turning the speed dial to position '0'.
CLEANING AND MAINTENANCE
Over the course of time dust can accumulate
between the spokes in the fan housing, and on
the fan blades. Always begin by trying to remove
the dust with a brush and/or vacuum cleaner. If
this does not remove all the dust you can always
dismantle the fan and clean it.
1. Remove the plug from the wall socket.
2. Use a small crosshead screwdriver to loosen
the screw at the bottom of the fan housing;
hold the bolt at the rear of the fan housing to
prevent it from turning.
3. Remove the front half of the fan housing.
4. Hold the fan blades to prevent them
from turning, and use a small crosshead
screwdriver to loosen the locking screw.
Remove the fan blades from the shaft.
5. Use a crosshead screwdriver to loosen the screws from the motor housing and then remove the
housing.
6. Clean the dismantled parts and the base with a damp cloth. Dry thoroughly with a dry cloth.
7. Clean the motor housing with a dry cloth.
6
a
b
8
28
7
EN

Publicidad

loading