Jet Cool; Forced Operation; Test Operation - LG SL182CR NC0 Manual Del Propietário

Jet Cool

Forced operation

Forced operation is used when the remote controller can't be used. The operation will be started if the ON/OFF
button is pressed. If you want to stop the operation, re-press the button.
Cooling Model
Operating mode Cooling
Indoor FAN Speed High
Setting Temperature 22°C

Test operation

During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature
and resets in 18 minutes. During test operation, if remote controller signal is received, the unit operates as remote controller
sets. If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1
'beep'. If you want to stop the operation, re-press the button.
Jet cool function can be used to cool the room quickly in hot summer. When this
function is turned on, the air conditioner runs in cooling operation mode with super
high fan speed and 18°C setting temperature for 30 minutes for fast and effective
cooling.
You can activate this operation by pressing the JET COOL BUTTON.
To change from jet cool mode to high fan speed cooling mode, press the
JET COOL BUTTON or INDOOR FAN SPEED SELECTOR BUTTON or the
ROOM TERPERATURE SETTING BUTTON again.
Room Temp. ≥ 24°C
Cooling
High
22°C
Heat pump Model
21°C ≤ Room Temp. < 24°C
Healthy Dehumidification
High
23°C
Operating Instructions
ON/OFF Button
Room Temp. < 21°C
Heating
High
24°C
Owner's Manual 17