Medisana 88970 Instrucciones De Manejo página 30

GB
3 Operating
3.1
Usage
3.2
Operation
20
The use of the shiatsu massage seat cover will improve your wellbeing after a
stressful day. The massage effect is particularly useful for treating tense muscles
and tired tissue. The unit provides pleasant relaxation for overcoming everyday
stress. The massaging can improve your well-being, and is also useful in the
sport and fitness areas.
Start-up
• The transport lock which is located on the rear of the backrest at the base,
must be removed before the device is first used (see illustration at the front
of the Instruction Manual). Be sure to observe the safety information (see
chapter 1 Safety instruction, sub-heading before using the device and
the according illustration at the front of this Instruction Manual).
• Place the massage seat cover on a high chair or armchair and attach it to this
by means of the fasteners
supported over its entire area and has a sufficiently high backrest.
5
• Insert plug into the mains socket. Ensure that the power supply is easily
accessible.
• Take a seat on the shiatsu massage seat cover and familiarise yourself with
the functions.
• Sit comfortably and upright. Ensure you sit centered and such that the
4
massage heads can move to the left and right of your spinal column.
Operating the unit
The MCN PRO shiatsu seat cover has three functions for an effective massage:
fingertip massage (Shiatsu massage), vibration massage and heat. The heat
function can only be used together with the shiatsu massage in the back,
during which the neck massage and the vibration massage in the seat can also
be activated. Do not use the unit for more than 15 minutes at a time. fter
approx. 15 minutes, the unit will switch off automatically.
unit to cool down fully before you use it again.
Buttons on the control unit
Use the buttons on control pad
Switch on the device by pressing O
device starts with standby mode. If no other button is pressed, the device turns
off after 15 minutes automatically.
8
Demo button
You may activate demo function with or without pressing On/Off button
before. Press the Demo button
introduction of different back setting with different functions.
First massages in neck /shoulder and full back region are presented. The
rotating back massage heads
to the entire top; the rotating neck massage heads
Simultaneously heat in the back and vibration in the seat are activated, while
intensity of vibration is set on lowest level.
1
on the back. Ensure that the seat cover is
7
to operate the massage seat cover:
t
n/Off button . The LED illuminates.
8
, the device starts automatically with
4
move from the entire bottom (start position)
lways allow the
The
t
2
move outwards.