TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 21

7. Lighting Control
Switch on the controller with the rear power switch. The
unit is in manual mode and the display indicates "Manual"
in the upper line.
Adjusting a Scene
A scene contains the values of all control channels includ-
ing the pan and tilt settings of the connected spotlights.
1. Use the FIXTURE buttons at the lower left to se-
lect the fixtures to be controlled. If a button is
pressed once again, the fixture is deselected.
- Instead of selecting each fixture indi-
vidually, units with consecutive numbers
can be selected simultaneously. For this,
press the first and last number button si-
multaneously.
- EXAMPLE For selecting the devices 1
to 4 press the FIXTURE buttons 1 and 4
simultaneously. Thus, all 4 devices will
be selected simultaneously. In the same
way, it is possible to deselect devices.
2. The 24 fixtures are split into 3 pages. If necessary,
use the PAGE button to switch between the pag-
es. The LEDs A, B and C indicate which page is
selected at that moment.
3. Adjust the desired DMX values for the DMX chan-
nels using the motor faders and, if necessary, the
PAN and TILT wheels.
- As soon as a fader is moved, the display
indicates the number of the control
channel in the lower line and the current
output value as a DMX value (0- 255).
- The motor faders always indicate the
current setting for the fixture selected.
When several fixtures are selected with
different settings, the faders indicate the
settings of the fixture selected last. If
the movement control with the encoder
wheels does not work, probably the PAN/
TILT button is engaged (SPEED LED
lights). Then the encoder wheels control
the effect parameters.
P. 21
NAVIGATOR EXPERT RDM
ENGLISH VERSION