Publicidad
Idiomas disponibles
Idiomas disponibles
Glossary of Terms
Arbor
The shaft on which a cutting tool is mounted.
Freehand
Performing a cut without the use of workpiece vise, hold
down or other proper device to prevent the workpiece
from twisting during the cutting operation. Twisting of the
workpiece can cause it to be thrown or cause the wheel
to break.
Kerf
The slot produced when the material is removed by the
abrasive wheel.
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
WARNING: To reduce the risk of electrical hazards,
fire hazards or damage to the tool, use proper cir-
cuit protection. Your machine is wired at the fac-
tory for operation using the voltage shown above.
Connect tool to a power line with the appropriate
voltage. To reduce the risk of shock or fire, if
power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Electrical Connections
NOTE: The plug supplied on your tool may not fit into the
outlet you are planning to use. Your local electrical code
may require slightly different power cord plug connec-
tions. If these differences exist refer to and make the
proper adjustments per your local code before your tool is
plugged in and turned on.
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped
with an electric cord having an equipment grounding con-
ductor and a grounding plug, as shown. The plug must be
plugged into a matching outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
Revolutions Per Minute (RPM)
The number of turns completed by a spinning object in
one minute.
Abrasive Wheel Path
The area of the workpiece or table top directly in line with
the travel of the abrasive wheel. This includes the part of
the workpiece which will be, or has been, cut by the
wheel.
Workpiece
The item on which the cutting operation is being per-
formed.
The AC motor used in this machine is a universal, nonre-
versible type having the following specifications:
Voltage
Amperes
Hertz (Cycles)
Phase
RPM
Rotation of Shaft Counterclockwise
3-Prong
Outlet
26
220-240
7.5
50-60
Single
3600
3-Prong
Plug
Publicidad
