RIDGID CM1400EXC Manual Del Propietário página 33

Before Leaving This Tool
Never Leave Tool Running Unattended.
• Turn power off.
• Wait for all moving parts to stop.
Basic Operations
General Cutting Instructions
WARNING: Always wear safety glasses when oper-
ating the cut-off machine. To reduce the risk of
burns from contact with hot cut off workpieces,
wear protective gloves.
WARNING:
a. Always securely fix the material to be cut by
using the vise.
b. Always disconnect the tool from power source
before making any adjustment.
c. Do not use any type of cutting lubricant with this
tool.
Familiarize yourself with the following functions of the
RIDGID cut-off machine before connecting it to a power
source and using it.
1. When starting this cut-off machine for the first time or
after it has been idle for awhile, always let the machine
run for one full minute with the wheel completely
recessed into the guard before making any cuts. If
there are any unknown defects in the wheel that could
cause breakage they usually would do so within the
first minute of operation. If the wheel wobbles or
vibrates, discard and replace immediately.
2. When beginning a cut with the tool, care should be
exercised not to bump or slam the wheel into the work;
once it has entered, continue the cut with an even
smooth stroke. The faster a cut is made the less heat is
created in the workpiece, preventing discoloring, and
wheel life is prolonged. Cut with a steady force without
overloading the motor.
3. Use an outboard support when cutting long, heavy
pieces to prevent them from tipping the machine or fall-
ing down after they are cut.
4. When transporting the machine use the chain to
secure the motor mount to the base to prevent dam-
age.
5. When cut-off wheel comes up to full speed, push the
handle to begin cutting. It is important to cut with
steady and even pressure (Do Not Force) in order to
obtain a uniform cut.
Make Workshop Child-proof.
• Lock the shop.
• Disconnect master switches.
• Store tool away from children and others not qualified
to use the tool.
WARNING: To reduce the risk of injury from unex-
pected tool movement:
a. Before moving this tool, lock the power head in
the lower position. Unplug electric cord.
b. To reduce the risk of back injury, hold the tool
close to your body when lifting. Bend your
knees so you can lift with your legs, not your
back. Lift by using the hand-hold areas at each
side of the bottom of the base or by the carrying
handle.
c. Never carry tool by the power cord or the trigger
grip of the plastic handle. Carrying the tool by
the power cord could cause damage to the insu-
lation or the wire connections resulting in elec-
tric shock or fire.
d. Place the machine so other people cannot stand
behind it. Thrown debris could injure people in
its path.
e. Place the tool on a firm, level surface where
there is plenty of room for handling and prop-
erly supporting the workpiece.
f. Support the tool so the table is level and does
not rock.
g. Bolt or clamp the tool to its support.
33