Publicidad
Idiomas disponibles
Idiomas disponibles
1. Flip directional switch to OFF.
2. Use repeated and forceful clockwise spins of the speed chuck handwheel at the front of the
Power Drive to release the work piece from the speed chuck jaws.
3. If necessary, loosen the rear centering device using a clockwise rotation of the handwheel at
the rear of the Power Drive.
4. Slide the work piece out of the Power Drive, keeping a firm grip on the work piece as it clears
the Power Drive. To avoid injury from falling parts or equipment tip-overs when handling long work
pieces, make sure that the end farthest from the Power Drive is supported prior to removal.
5. Clean up any spills or splatter on the ground surrounding the Power Drive.
WARNING!
Make sure machine is unplugged from power source before performing maintenance or making
any adjustment.
1. Clean teeth of jaw inserts daily with wire brush.
2. Replace jaw inserts when teeth become worn and fail to hold pipe or rod.
NOTE! Replace entire set of jaw inserts to insure proper gripping of the pipe or rod.
1. Place screwdriver in insert slot and turn 90 degrees in either direction.
2. Place insert sideways on locking pin and press down as far as possible.
3. Hold insert down firmly with screwdriver, turn until teeth face up.
Pipe reaming operation
REMOVING PIPE FROM THE POWER DRIVE
MAINTENANCE INSTRUCTIONS
JAW INSERTS
JAW INSERT REPLACEMENT
19
Publicidad
