BH LK5500 Manual De Instrucciones página 10

ENGLISH
GENERAL INSTRUCTIONS.-
The electronic monitor is designed to be easy and intuitive to use. The messages that appear on the bottom
screen (B) will guide the user throughout the whole exercise.
Nevertheless, we recommend that the gym instructor reads through this section carefully to become fully
familiar with the electronic monitor in order to show the user how to operate it correctly.
This monitor screen is touch sensitive, so to press a key just place your finger on the said key displayed on
the screen.
PERSONALISING THE ELECTRONIC MONITOR.-
Follow the procedure below to access the monitor's personalisation mode:
Set the mains switch (b), located at the bottom front of the machine, to the position (1) Fig.A.
Fig.A
1) CHANGING LANGUAGE.-
From the main menu, press both the STOP key and the ENTER button for 3 seconds. The software version
will appear on the alphanumeric screen (B), Fig.1, press both the STOP key and the PAUSE button for 3
seconds. Select your language using the SPEED▲ and SPEED▼ keys and then press START. If you wish
to exit the persnalization mode, press the RESET key and the manual program will be displayed on the LED
array (A).
2) CHANGING FROM km to Miles.-
From the main menu, press both the STOP key and the ENTER button for 3 seconds. The software version
will appear on the alphanumeric screen (B), Fig.1, press both the STOP key and the ENTER button for 3
seconds. To change from km to miles press the ENTER key until UNITS appears, this will take you to the
change option, displaying "KM" on screen (B). Use the SPEED▲ and SPEED ▼ keys to select the speed
measure scale (METRIC / km. -- IMPERIAL / Miles) and press the START key. If you wish to exit the
persnalization mode, press the RESET key and the manual program will be displayed on the LED array (A).
ELEMENTS OF THE ELECTRONIC MONITOR (Fig.1).-
The electronic monitor is made up of two distinct areas:
The top area, Fig.2 (A – B – C) for the DISPLAY
The bottom area, Fig.3 (E – F – G) for the KEYPAD
DISPLAY.-
This area comprises of two screens.
(A) The top LED array, which displays real-time exertion levels being produced during the selected program.
(B) Bottom alphanumeric screen, which guides the user selection options and exercise.
The top screen (A) displays the various pre-programmed exercise profiles (programs) that we can select and,
during exercise, current exertion levels.
The bottom alphanumeric screen (B) is used to guide the user when selecting the exercise to do, as well as
displaying information about the exercise both during and after the session. The LED indicators (C) located
below the alphanumeric screen give a simultaneous readout of SPEED; TIME / DISTANCE; CALORIES /
WATTS; PULSE RATE and indicate which information is being displayed throughout the exercise.
The data that are displayed on the LEDs (C) during exercise are as follows:
-SPEED: This displays the linear velocity at which the belt is travelling. The value is displayed in kilometres
per hour (km/h).
10