C A R E A N D C L E A N I N G
MAINTENANCE
Cleaning the Water Inlet Filters
If the washer detects that water is not entering
the dispenser, an error message will show on the
display. If you live in an area with hard water, this
may be caused by clogged inlet filters.
IMPORTANT: Use extreme care when removing
and cleaning the filters. If the filters cannot be
cleaned or are damaged, do NOT operate the
washer without the inlet filters. Contact LG
Customer Service or a qualified LG servicer.
1
Turn off both water taps completely. Unscrew
the hot and cold water lines from the back of
the washer.
IMPORTANTE: Use ONLY the inlet hoses
provided by LG with this laundry product.
Aftermarket hoses are not guaranteed to fit or
function correctly. Other hoses may not tighten
correctly and could cause leaks. Subsequent
damage to product or property will not be
covered under the terms of LG's warranty.
Inlet Filter
Carefully remove the filters from the water
2
inlets, and soak them in white vinegar
or a lime scale remover, following the
manufacturer's instructions. Rinse thoroughly
before reinstalling.
Press the filters back into place and reattach
the water lines. Do NOT operate the washer
without the inlet filters.
MAINTENANCE
(cont.)
Cleaning the Drain Pump Filter
Lint and other objects may accumulate and clog
the drain pump filter. If the washer fails to drain
properly, unplug the washer and allow the water
to cool, if necessary, before proceeding.
1
Open the drain pump filter access panel.
Pump
Filter
Plug
3
Remove the plug from the drain hose, and
allow the water to drain completely.
Twist the pump filter counterclockwise to
remove. Remove any lint and foreign objects
from the pump filter.
Reverse the above steps to reinstall the drain
pump filter and drain hose. Be sure to close
the cover panel when finished.
C A R E A N D C L E A N I N G
Drain Hose
Unclip the drain hose and pull it out. Place
2
the end of the drain hose in a pan, bucket, or
floor drain to catch water.