Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 8

Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 3
å
Insert two WOOD DOWELS (42F) into the
LARGE END (C).
å
NOTE: You may need to gently tap the
WOOD DOWELS in with your hammer.
å
Fasten the LARGE END (C) to the
MODESTY PANEL (E). Tighten three
TWIST-LOCK® FASTENERS.
å
NOTE: Be sure the WOOD DOWELS in
the LARGE END insert into the
MODESTY PANEL.
Page 8
FASTENER
®
If the TWIST-LOCK® FASTENER
is already inserted in the part,
be sure both the dowel end and
fastener edge are straight.
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Edge with
TWIST-LOCK®
42F
FASTENERS
C
i t h
e w
®
f a c
C K
S u r
- L O
I S T
E R S
T W
T E N
F A S
42F
For support, place packing
foam or books here.
427439
Edge with
TWIST-LOCK®
FASTENERS
S u r
f a c
E
e w
i t h
T W
I S T
- L O
C K
® F A
S T E
www.sauder.com/commercial-office/service
Dowel end
2
N E R
S