KIKKA BOO CALMO Instrucciones De Uso página 8

EN
IMPORTANT! KEEP FOR FUTURE REFERENCE.
WARNING
Never leave the child unattended.
WARNING
Do not use the reclined cradle once your child can sit unaided.
WARNING
This reclined cradle is not intended for prolonged periods of sleeping.
WARNING
It is dangerous to use this reclined cradle on an elevated surface, e.g. a table.
WARNING
Always use the restraint system.
• This reclined cradle is suitable for one child from birth to a maximum weight of 9kg.
• This reclined cradle does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a
suitable cot or bed.
• Do not use the reclined cradle if any components are broken or missing.
• Do not use accessories or replacement parts other than those approved by the manufacturer.
This product complies with EN 12790:2009
I. PARTS
Seat x 1, Base x1
II. ASSEMBLY
Step 1: Turn outwards the stand.
Step 2: Rotate the seat support to the locking position.Rotate untill you here "click" at both side.
Step 3: Slide the seat support to the bouncer base. Slide in untill you here "click" at both side.
III. REMOVE SEATPAD
Step 1: Open the velcro cover.
Step 2: Unzip the seat pad, untill the seat pad is completely removed.
Assembly the seat pad in reverse order of remove the seatpad.
IV. FUNCTIONS
4.1. Backrest adjustment.
Press the button on both sides of the seat to adjust the backrest angle. There are 2positions.
4.2. Rocking mode(A) and Stand mode(B).
V. HOW TO FOLD
5.1. Remove the seat
Step 1: Press the lower button on the seat support internal side.
Step 2: And at the same time slide out the seat support. Remove one side the nthe other side.
5.2. Fold the seat support
Step 1: Press the upper button on the seat support internal side.
Step 2: And at the same time, press the round button at the seat support outter side.
Apply the above action at both side of the seat , and keep the these four button at pressed condition, then roate
the seat support towards the backrest tube.
CLEANING AND MAINTENANCE
This product requires regular maintenance to keep it in good working order. Regularly check all parts of the product to ensure that they are operating correctly
and for signs of wear or damage. Only replacement parts supplied or recommended by the manufacturer should be used.
1. Before using the product for the first time, please check whether all parts are well fixed or whether the tightening mechanism are well tightened.
2. Regularly check the condition of the main parts and locking mechanisms, whether they are in good condition. If you establish damage, please stop using the
product until the broken part is replaced. Do not make repair of the product by yourself, but contact with authorized repair shop or the sales manager, which you
bought the product from. Otherwise your warranty will be cancelled.
3. Do not use accessories or replacement parts other than those, approved by the manufacturer.
4. The fabric of the product must be cleaned with warm water and mild soap. Refer to care label on the product for cleaning instructions for fabrics.
5. After cleaning, leave the product to dry well before using it. It is absolutely forbidden to fold it and storage it before it is completely dry.
6. Do not use strong cleaning agents, whitener or agents with abrasive particles for cleaning the product. It is forbidden its cleaning in washing machine, dryer,
through dry cleaning whitening and centrifugation.
7. Clean plastic parts with soft towel and dry with dry soft towel.
8. Clean metal or plastic components with mild detergent and warm water.
INSTRUCTIONS FOR STORAGE
1. When you do not use the reclined cradle, please, storage it on dry, windy and safe place. Do not storage the product in dusty, moisture room with very low or
very high temperatures.
2. Storage the product away from children.
3. Storage the product on dry and clean place. Do not expose the product on the direct sunlight, rain, moisture or sharp temperatures.
Attention! Keep away from fire. Do not store the product near heat sources or in direct sunlight for a long time to prevent deformation.
ENGLISH