Fontastic Tonic Manual Del Usuario página 2

GB
User Manual
Thank you for purchasing this Fontastic
with active noise cancellation. Please read the Manual
carefully and observe the safety instructions. Please keep
these operating instructions for future reference.
Package contents
• Fontastic Headphone Tonic
®
• USB charging cable
• 3.5 mm audio cable
• This user manual
Overview
1
2
3
4
5
6
7
8
1. ANC LED
2. ANC switch
3. Volume+ | next track
4. Volume- | previous track
5. Multifunction button (on/off, music start/stop, phone functions)
6. Status LED
7. USB Type-C
port
®
8. 3.5 mm line-in port
9. Microphone
10. Speaker
11. Height adjustment
Charging the battery
The Fontastic Tonic is equipped with an internal rechargeable
®
battery. Connect the Tonic with the USB Type-C
included in the package contents.
The cable can be connected to a computer or a standard USB
power supply. The Tonic's red LED lights up during the charging
1
headphones „Tonic"
®
11
10
9
cable which is
®
process. When fully charged, the red LED goes out.
The cable can be disconnected from the Fontastic
Note: Fully charge the Tonic before using it for the
first time.
Adjusting the height / folding the speakers
To adjust the height, hold the speaker unit and pull the headpho-
ne bracket upward. Adjust the headphones in this way until the
ear pads sit exactly on the ear. The headphones can be folded
for space-saving storage or transport.
Switching On /Off
To switch on, press the multifunction button for 3 seconds, an
acoustic signal sounds, the blue and red LED flash alternately.
To switch off, press the multifunction button for 3 seconds, an
acoustic signal sounds, the LED goes off.
Pairing
Tonic must be paired with a Bluetooth
used as wireless headphone with hands free function.
1. In the off state, press and hold the multifunction button (5) for
3 seconds to turn on. Keep the button pressed and wait until
the blue and red LED flashes alternately. This indicates the
pairing mode.
2. Search for „Tonic" on your Bluetooth
select it from the list of found devices to connect the
headphones to the Bluetooth
3. Confirm the connection with Tonic.
If you are unsure about the pairing procedure of your Bluetooth
device, please check your device manual. When using a
Bluetooth transmitter without display, set it to pairing mode and
®
wait a few seconds until the connection with Tonic is established.
Note: If the connection is lost or the transmitter is temporarily
disconnected, briefly press the multifunction button. Tonic will
then try to restore the connection.
Note: The connection is disconnected during the charging pro-
cess. The headphones turn off, and the on/off button is disabled.
Tonic.
®
device before it can be
®
enabled device and
®
device.
®
GB
®
2