3. TECHNICAL DATA
Voltage
40V
No-load speed
Blade length
Cutting length
Cutting diameter
Machine Weight
(Bare Tool)
** X may be followed by one or two characters. All
models are the same except model number and
trademark. The suffix in models may be number
from "1" to "999" or English letter "A" to "Z" or "M1"
to" M9" which means different package or the
various of accessories packed in the package.
*** Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category
Type
WA3575
20V Battery
WA3669
WA3770
20V Charger
WA3884
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose
the type according to the work you intend to
undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
4. INTENDED USE
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
40V Cordless Hedge trimmer
WG286 WG286.X**
MAX(2x20V MAX)***
3400/min
24"(61 cm)
23"(58 cm)
1" (27 mm)
5.9 Ibs (2.7 kg)
Capacity
2.0 Ah
2.0 Ah
2.0 A
4.0 A
5. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Warning! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Installing and Removing the battery
pack
NOTE :
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
• When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
OPERATION
FIGURE
See Fig. A
See Fig. B1,
B2
See Fig. C
11
See Fig. D
EN