Publicidad
Idiomas disponibles
Idiomas disponibles
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated, your
battery is overly discharged, even though
the trimmer may still be capable of
hedge trimming. Continuing to operate
your trimmer with the battery in this
discharged condition may reduce the life
and performance of your battery.
When no light is illuminated, at least
one battery is not fully installed or
battery may be defective, please double
check the batteries are fully seated into
position.
Remove the blade sheath
Starting and stopping
Rotating rear handle
NOTE :
• Unlock the locking switch before
rotating.
• After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
WARNING:
• Always make sure that the handle
12
is locked in the desired position
before operation.
• Always make sure the locking
switch is locked before starting the
hedge trimmer.
• Do not rotate the handle when the
trimmer is being operated.
Top cutting
WARNING: If any parts are
missing, damaged or broken,
do not operate your hedge trimmer
until all damaged parts have been
replaced or repaired. Failure to do
so could result in serious personal
injury. DO NOT USE WITHOUT FRONT
HANDLE AND SAFETY GUARD.
Side cutting
WARNING: Stop operating the trim-
mer before rotating the handle.
Lubricating the cutting blade
NOTE : It is important to use only the
recommended standard lubricating
oil (WD-40) to avoid damage to the
blade.
40V Cordless Hedge trimmer
6. HOW TO USE YOUR
HEDGE TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
See Fig. E
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
See Fig. F
If the blade stalls, immediately stop the trimmer.
Release the Operator Presence Switch and Throttle
See Fig. G1,
Trigger before attempting to clear jammed debris
G2
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
Top cutting
Use a wide sweeping motion A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
See Fig. H1,
Side cutting
H2
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the
hedge, resulting in a more uniformed growth
BATTERY STATUS (See Fig. E )
•
Before starting or after use, press the button beside
the power indicator light on the machine to check the
battery capacity.
•
During operation, the battery capacity will be indicated
automatically by the battery power indicator. The
indicator constantly senses and displays the battery
condition as follows.
See Fig. I
•
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery indicator light
See Fig. J1,
Five green lights
J2
(
illuminated.
See Fig. K
Two, three or four green
lights are illuminated.
Battery condition
status
The two batteries are in a highly
) are
charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the more
battery capacity.
EN
Publicidad
