Publicidad
Idiomas disponibles
Idiomas disponibles
Change Grill Main Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the cotter clip that hold the burner in place.
Remove the burner from the grill by lifting the burner out.
3. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve.
Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly
installed inside of the burner opening.
4. Reinsert the burner and reattach using the cotter
pin previously removed. Repeat the procedure for
each main burner.
5. Position the igniters so they are 1/8" (3.2 mm)
away from each burner.
!
Change the Sear Burner Orifice
All manuals and user guides at all-guides.com
1.
Remove the 1 screw which was pre-assembled on
sear burner pin. Unplug sear side burner wire from
igniter. Remove the two screws which pre-
assembled on sear burner, then lift sear burner out
from sear burner firebox, as shown below.
2. Use 6 mm socket wrench or 6 mm nut driver to remove
the orifice. Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly installed
inside of the valve.
3. Reinstall sear burner, tighten the sear burner orifice
brass connector and sear burner tube by using a wrench.
4. Open the manual shutoff valve in the gas supply. The
valve is open when the handle is parallel to the gas pipe.
5. Test all connections using an approved noncorrosive
leak- detection solution. Bubbles will show a leak. Correct
any leak found.
21
Publicidad
