Palmer PCAB112BX Manual De Instrucciones página 19

USER MANUAL
1.2) 2X12 CABINETS
The below picture shows the jackplate for the 212 cabinets.
1.2.1) MONO AND STEREO MODE
TO RUN THE CABINET IN MONO MODE
Connect the speaker out of your amplifier to the socket marked "Left/Mono". In this case both speakers are wired in
parallel and both will sound.
Example: If the cabinet is loaded with two 16 Ohms speakers, then the total impedance at the "Left/Mono" socket will
be 8 Ohms.
TO RUN THE CABINET IN STEREO MODE
First connect the socket marked "Right". As soon as a jack connector is plugged into this socket, the connection between the
two speakers is broken. The cabinet can now be used like two individual 112 cabinets. The signal/amp connected to the "Right"
socket will feed the right speaker and the signal/amp connected to the "Left/mono" socket will feed the left speaker.
NOTE
Switching between the modes Mono and Stereo is done via a switching jack socket used for the "Right" input – plugging a jack
connector to this socket will switch the cabinet into stereo mode. When in Stereo mode, each speaker runs individually. If your
cabinet is loaded with 16 Ohms speakers, then you will have 2x 16 Ohms inputs.
19
EN