Beurer 643.27 Instrucciones De Uso página 24

3. a. Then undo the hook-and-loop fas-
teners and take the cuffs off. Re-
move the white air hoses on the
„Y-adapter" from the leg cuffs,
but leave the short, white end pi-
eces on the leg cuffs as shown.
Also remove the air hose from the ad-
apter that is located directly on the
thigh cuffs. If you used the device
with the mains part, remove it from
the socket and the hand switch.
3. b. Then undo the hook-and-loop faste-
ners and take the cuffs off. Remove
the grey air hoses on the „Y-adapter"
from the leg cuffs, but leave the short
end pieces on the leg cuffs as shown.
If you used the device with the mains
part, remove it from the socket and
the hand switch.
10. Cleaning and maintenance
10.1 Cleaning the cuffs
• Always switch the device off before cleaning and remove the air hoses (apart from the short end pieces) from
the cuffs and the hand switch.
• Clean the cuffs with a soft, slightly damp cloth. Do not use any chemical or abrasive cleaning agents for cleaning.
• Do not use the cuffs until they are completely dry.
10.2 Storage
• If you do not intend to use the device for longer periods, remove the batteries from the hand-held device.
Leaking batteries may damage the device.
• Do not make sharp kinks in the air hoses and the cuffs.
• Store the device and accessories in a cool, well-ventilated space in its original packaging.
11. What if there are problems?
Problem
Cuffs do not inflate
The timer LEDs on the hand-held
device start to flash during the
treatment and the vein massager
switches itself off
If you cannot find a solution to your problem here, contact our Customer Services.
1.
Possible cause
Batteries are flat
Mains part not plugged in
Air hoses are not correctly connected Reconnect the air hoses.
Batteries are flat
24
Solution
Replace the batteries in the hand
switch.
Plug the mains part into a suitable
socket.
Replace the batteries in the hand
switch.
2.